Mechanical Characterisation for Numerical Simulation of Extrusion-Based 3D Concrete Printing (2021-07)¶

10.1016/j.jobe.2021.102944

van den Heever Marchant, Bester Frederick, Kruger Jacques, van Zijl Gideon
Journal Article - Journal of Building Engineering, Vol. 44

Abstract

Extrusion-based 3DCP is experiencing exponential advancement in process, control, material, and fresh-state analysis technologies, strategically poising 3DCP to become an industrial manufacturing process for infrastructure development. To elucidate the mechanical characterisation and numerical simulation of3DCP elements synergy among experimental and computational mechanics is required. Such activities should characterise the unique material properties of printed components to permit limit state design procedures and the correct prescription of finite element (FE) model parameters. In this research, mechanical characterisation procedures that experimentally evaluate the anisotropic material characteristics of a fibre-reinforced printable concrete (FRPC) are presented. These procedures are comprised of direct tensile, uniaxial compression, Young's modulus, and four-point bending (FPB) crack mouth opening displacement (CMOD) tests. The results portrayed anisotropic non-linear and similar elastic behaviour (in terms of Young's modulus) in all experimental tests conducted. From the mechanical characterisation tests two elastic parameters, seven strength parameters and five inelastic parameters are ascertained. The experimental findings relating to the material characteristic parameters are validated via supplementary numerical evaluation, and suitable constitutive relations are selected. The mechanical parameters are implemented in an anisotropic Rankine-Hill continuum multi-surface plasticity FE model, and the FPB-CMOD fracture response of 3DCP specimens is simulate with respectable agreement.

¶

34 References

73 Citations

BibTeX

@article{heev_best_krug_zijl.2021.MCfNSoEB3CP,
  author            = "Marchant van den Heever and Frederick A. Bester and Jacques Pienaar Kruger and Gideon Pieter Adriaan Greeff van Zijl",
  title             = "Mechanical Characterisation for Numerical Simulation of Extrusion-Based 3D Concrete Printing",
  doi               = "10.1016/j.jobe.2021.102944",
  year              = "2021",
  journal           = "Journal of Building Engineering",
  volume            = "44",
}

Formatted Citation

IEEE

M. van den Heever, F. A. Bester, J. P. Kruger and G. P. A. G. van Zijl, “Mechanical Characterisation for Numerical Simulation of Extrusion-Based 3D Concrete Printing”, Journal of Building Engineering, vol. 44, 2021, doi: 10.1016/j.jobe.2021.102944.

CMOS

Heever, Marchant van den, Frederick A. Bester, Jacques Pienaar Kruger, and Gideon Pieter Adriaan Greeff van Zijl. “Mechanical Characterisation for Numerical Simulation of Extrusion-Based 3D Concrete Printing”. Journal of Building Engineering 44 (2021). https://doi.org/10.1016/j.jobe.2021.102944.